NOx Sensor 04L907805AR
201362

NOx Sensor 04L907805AR

BG NOx sensor for VWCaddy IV / Caddy Alltrack,OE 04L907805AR,12V urea/SCR system.

BG Part Number
201362
Category
NOx Sensors
Application
Caddy IV / Caddy Alltrack
Voltage
12V
Vehicle Manufacturer
VW
OE Cross References
  • 04L907805AR

Product Description

This BG NOx (nitrogen oxide) sensor is designed for the urea/AdBlue-based SCR (Selective Catalytic Reduction) emissions system on VW Caddy IV / Caddy Alltrack. It is a direct-fit replacement for OE reference 04L907805AR. Rated for 12V electrical systems. The sensor provides accurate real-time NOx measurement for precise urea dosing control, helping maintain stable SCR performance and compliance with diesel emission standards.

Vehicle manufacturer names, logos and OE reference numbers are used for identification and compatibility purposes only. BEST GROWTH products are independent aftermarket products and are not manufactured, sponsored or endorsed by the respective vehicle manufacturers.

BG 201362 (OE 04L907805AR): function on the vehicle

NOx Sensor 04L907805AR is supplied by BEST GROWTH under part number 201362, cross-referenced to OE 04L907805AR, as a direct-fit aftermarket nox sensors. In service it measures nitrogen-oxide concentration and residual oxygen in the exhaust stream and reports both values to the aftertreatment controller over the vehicle data bus. Upstream and downstream readings together set DEF dosing quantity and score SCR conversion efficiency.

BG 201362 is built to the position defined by its OE application on a 12V electrical system on the platform from Volkswagen. Position, calibration and connector layout are part of the specification, so a part that physically fits is not automatically the correct part.

Cable length and connector keying are part of the specification. A cell with correct electrical output but the wrong lead length will not route to the OE bracket.

Fitment for Volkswagen and OE cross reference

BG 201362 replaces 1 OE reference: 04L907805AR. Always confirm the number printed on the removed part, including any supersession issued by the vehicle manufacturer.

Recorded vehicle coverage for 201362 includes Volkswagen, typically on Caddy IV / Caddy Alltrack. Coverage lists are a starting point for identification, not a substitute for checking the OE number on the vehicle.

Quote the number printed on your part with the engine code when you enquire; a single-reference part is the most common source of ordering errors when a platform received a mid-life update.

Symptoms that lead to replacing 04L907805AR

These complaints bring a vehicle in with the Volkswagen nox sensors under suspicion. None of them prove BG 201362 has failed on its own, which is why the checks below matter before a replacement is ordered.

  • DEF over-consumption with no visible leak
  • torque derate or speed inducement with a full, in-spec DEF tank
  • no communication with the sensor control module after a cold start
  • sensor value frozen at a fixed number once the exhaust warms up
  • dosing shut-down after a few minutes of steady-state running

Checks before fitting BG 201362

Aftertreatment faults are usually system faults. Working through these checks prevents a repeat failure after the new nox sensors is fitted.

  • Compare upstream and downstream NOx readings warmed and under load — idle values prove nothing.
  • Confirm supply voltage, ground quality and bus termination before condemning the sensor module.
  • Inspect the harness for heat damage and the connector for moisture and green corrosion.
  • Check for exhaust leaks ahead of the sensor boss; a diluted sample reads low NOx.
  • Read the sensor's own dew-point release time — a cell that never heats is a supply or module fault.

Quality, packaging and ordering 201362

BG 201362 is manufactured and tested to aftermarket replacement standards, with electrical, leakage and functional testing carried out before packing on the 12V specification. Bulk and retail packaging, private-label cartons and customer-specific labelling are available for distributors and workshop groups.

Send OE 04L907805AR or the number printed on your part, the engine code and the vehicle identification number with your enquiry, and our technical team will confirm the correct reference, current stock position and lead time before you commit to an order.

Frequently asked questions

Does BG 201362 replace OE 04L907805AR?
Yes. BG 201362 is listed against 04L907805AR. Confirm the number printed on the removed part and any manufacturer supersession before ordering.
Which vehicles does BG 201362 fit?
Recorded coverage includes Volkswagen. It is supplied as a direct-fit aftermarket nox sensors on 12V systems. Adaptation, reset or relearn procedures required by the vehicle manufacturer still apply after installation.
Does this fault code always mean the nox sensors has failed?
No. Exhaust leaks, wiring and connector damage, reductant quality, dosing performance and upstream engine faults can all produce the same codes. Validate those inputs before replacing BG 201362.

Related References

WhatsApp